Original Low profile 60 deg Installation Kit Under Eave Soffit Horizontal Adapter Mount for Floodlight Security Camera Ring Lorex Feit Eufy

Details

Now Available!
Installing RING floodlight cameras under the eaves of your building can be a pain. the angle of view is never right. This mount fixes that issue.

at just over 4" tall, it mounts to your eave junction box, and then the RING floodlight camera mounts to it. Everything is neat and tidy.

This is a 3D Printed Electrical Box Extension Kit for devices like RING floodlight cameras.
It includes:

1 PETG extension

4 - #8x3/4" Screws
4 - #8x1.25" screws


1 - 1/8 lamp cross bar
1 - 1/8 x 2.5" lamp pipe
1 - 1/8 lamp rod nuts
1 - 1/8 lamp rod nut in plastic cap

1 - 4" round junction box Weather Seal
1 - Single Gang box seal


1 - set of 14g stranded wire pigtails
6 - wire nuts


This extension will mount to a 4" Round Electrical Junction Box using the included #6 screws or with the crossbar and the lamp pipe.
This extension will mount to a single gang junction box with the crossbar and the lamp pipe.

The most versatile mounting option is the lamp pipe.

1.) Kill power
2.) Remove old fixture, and any attachment hardware.
3.) attach pigtails to current wiring.
4.) Place two screws through the 4” weather seal and the 1/8 IPS crossbar and attach to the holes on the junction box.
5.) Screw the 5" 1/8 IPS Lamp pipe into the crossbar, (add a washer and nut to the top above the crossbar, if desired).
6.) Guide the pigtails through the extension as you slide it up the lamp pipe, loosely secure with white cap so that it can be positioned properly .
7.) Connect pigtails and install camera onto extension.
8.) Turn power back on and setup camera.
9.) Twist extension to proper position, then tighten cap to secure position.